Table of Contents
Advertisement
8.
Once the settings are shown, scroll down to "Instruments Operation" and click "Toggle
display."
9.
Click "Save"
10.
When saving is complete, exit Safety Suite Device Configurator (SSDC) and disconnect
the USB cable.
11.
Press [Y/+] on the MultiRAE.
Note: If you want to disable this feature and only see the reading without the correction factors,
follow the same procedure, but instead of selecting "Toggle display," deselect it.
Enabling Benzene Operation & Sep-Tube Cartridge Tutorial
(MultiRAE & MultiRAE Pro with 9.8eV Lamp Installed)
The MultiRAE or MultiRAE Pro equipped with a 9.8eV PID lamp must have benzene operation
enabled through Safety Suite Device Configurator (SSDC). Also, its display can show an
animated tutorial to guide using a Benzene Sep-Tube Cartridge. To enable these features, you
must do the following:
1.
Use the USB cable to connect the instrument to a PC running Safety Suite Device
Configurator (SSDC).
2.
Step through the screens on the MultiRAE or MultiRAE Pro using the [N/-] button until
you see the screen that says, "Enter Communications Mode."
3.
Press [Y/+].
4.
With "PC" selected, press [Y/+].
5.
Start Safety Suite Device Configurator (SSDC).
6.
Log in (default username is "administrator". Default password is "Default123").
7.
Click on the serial number from the device.
8.
Click "Settings."
9.
Under "Instrument User Preferences" click to enable "Tube Mode".
10.
In "Settings", a tutorial feature can optionally be enabled. It shows, on the instrument
screen, how to operate the device with the RAE-Sep Tube for benzene sensing. Click the
checkbox to enable "Tutorial Status."
Honeywell MultiRAE Series™
56
User Manual
Advertisement
Table of Contents
