Honeywell MultiRAE Series User Manual page 28

General Status Icons
Pump status (only on pump-equipped models)
Datalogging status (shown when datalogging is on, blank when off)
Battery status (three segments show battery charge level)
Man Down alarm enabled
Sensor due for calibration
Sensor due for a bump test
"All sensors tested and calibrated to policy" tick mark (all sensors have been bump
tested and calibrated; no sensor is overdue for a bump test or calibration according to
the intervals configured on the instrument)
Keys and Interface
The MultiRAE has three keys:
Y/+ MODE
In addition to their labeled functions, [Y/+], [MODE], and [N/-] act as "soft keys" that control
different parameters and make different selections within the instrument's menus. From menu
to menu, each key controls a different parameter or makes a different selection.
Three panes along the bottom of the display are "mapped" to the keys. These change as menus
change, but at all times the left pane corresponds to the [Y/+] key, the center pane corresponds
to the [MODE] key, and the right pane corresponds to the [N/-] key. Here are examples that
show the relationships of the keys and functions:
In addition to the functions described above, any of the keys can be used to manually activate
display backlighting. Press any key when the backlighting is off to turn it on. A subsequent key
press is required to carry out an actual function corresponding to that key.
Honeywell MultiRAE Series™
N/-
23 User Manual