Honeywell MultiRAE Series User Manual page 104

Clear Datalog
This operation erases all data stored in the datalog. Select "Clear Datalog," and then "Yes."
Note: Once the datalog is cleared, the data cannot be recovered.
Datalog Interval
Intervals are shown in seconds. The default value is 60 seconds. The maximum interval is 3600
seconds, and the minimum is 1 second.
Sensor Selection
You can choose which sensors' data are included in the datalog. The entire list of installed
sensors is shown, and you can individually select whether their data is included.
Note: Turning a sensor off in the list does not change or erase its settings.
Data Selection
Data Selection allows you to select which types of data are stored and made available when you
download your datalog to a computer via Safety Suite Device Configurator (SSDC) (version
3.2.0 or higher) software.
You can choose any or all of four types of data (you must choose at least one):
Minimum
l
Average
l
Maximum
l
Real Time
l
Honeywell MultiRAE Series™ 99 User Manual