Table 9-9 Internal Error Messages - Honeywell VPR100 User Manual

Internal error messages
In addition to diagnostic messages, error messages are presented to indicate an internal fault. To correct the
problem, Table 9-9 lists suggested actions you should take, in the order you should take them. To
acknowledge or clear the error message, see Section 7.4 Access Summaries.
Error message
NONV RAM ERROR
PROCESSOR EXCEPTION
PROCESSOR RESET
TASK INIT FAILURE
QUEUE READ FAILURE
RESPONSE FAILURE
REQUEST FAILURE
AED REPORT FAILURE
AED HANDSHAKE FAILURE
FB TASK OVERRUN
AI TASK OVERRUN
12/00

Table 9-9 Internal Error Messages

1. Reduce the configuration by eliminating function.
2. Call service provider.
1. Reset unit.
2. Clear configuration and reload.
3. If message recurs, replace CPU.
1. Reset unit.
2. Clear configuration and reload.
3. If message recurs, replace CPU.
1. Reset unit.
2. Clear configuration and reload.
3. If message recurs, replace CPU.
1. Reset unit.
2. Clear configuration and reload.
3. If message recurs, replace CPU.
1. Reset unit.
2. Clear configuration and reload.
3. If message recurs, replace CPU.
1. Reset unit.
2. Increase scan rate to higher time; for example, from 500 msec to 1 second.
3. Clear configuration and reload it.
4. If message recurs, replace the CPU.
1. Reset unit.
2. Increase scan rate to higher time; for example, from 500 msec to 1 second.
3. Clear configuration and reload it.
4. If message recurs, replace the CPU.
1. Reset unit.
2. Increase scan rate to higher time; for example, from 500 msec to 1 second.
3. Clear configuration and reload it.
4. If message recurs, replace the CPU.
Increase scan rate to higher time; for example, from 500 msec to 1 second.
1. Check for noise. See Appendix B for noise suppression.
2. Increase scan rate to higher time; for example, from 500 msec to 1 second.
VPR & VRX – User Manual
Suggested Action
On-Site Adjustments
continued
273