Table 4-71 Prompts For Storage Setup Of Trends, Alarms, Events, Diagnostics - Honeywell VPR100 User Manual

Programming Function Blocks and Features

Table 4-71 Prompts For Storage Setup Of Trends, Alarms, Events, Diagnostics

Prompt
STORAGE MODE CONTIN, BATCH, or NONE
COPY DISPLAY
SETUP
POINT #1 - POINT #6 Analog or discrete parameter
(VPR100 & VRX100)
POINT #1 - POINT #12
(VRX150)
LOW RATE Seconds: .5, 1, 2, 3, 4, 5, 6,
7, 8, 9, 10, 20, 30, 40, 50
Minutes: 1, 2, 3, 4, 5, 10, 15
20, 30, 40, 50
Hours: 1
HIGH RATE Seconds: .5, 1, 2, 3, 4, 5, 6,
7, 8, 9, 10, 20, 30, 40, 50
Minutes: 1, 2, 3, 4, 5, 10, 15,
20, 30, 40, 50
Hours: 1
ROLLOVER ON, OFF
SET DISPLAY OFF or number
LIMITS
172
Range/Selections
VPR & VRX – User Manual
Definition
Continuous storage becomes active immediately upon
initialization. Batch storage is controlled by a discrete
parameter (see BATCH CONTROL) or by start/stop batch
menu item. Batch data may be started and stopped several
times in a single file until the file is full. Batch start
increments a batch number that is stored along with the
data. The batch number may be used for data retrieval and
analysis using SDA data analysis software.
Select this to copy the following Trend 1 or 2 Display data to
Trend 1 or 2 Storage data: Point #1–#6, set display limits,
timebase (high rate) selector. Once setup is copied, it can
be altered.
Select the data points for the trend.
Enter data collection rate. This is how often the data points
are sampled. The .5 sec rate cannot exceed 6 points total
in Trends 1-3.
Enter data collection rate. This is how often the data points
are sampled. The .5 sec rate cannot exceed 6 points total
in Trends 1-3.
Select ON to continue gathering and storing data after the
file becomes full. The new data will replace the oldest data
on the disk as it is collected. No warning will be given.
Select OFF to stop storage of this data type when the disk
space for it becomes full. A "DISK FULL" message will then
appear. Data is buffered until a new disk is inserted and
initialized.
Enter upper and lower limit values for the trend display for
each point. If NONE then the trend will use the programmed
limits for each point.
12/00