Table of Contents
Advertisement
Online Operations Using Primary Displays
To perform this action
Lower or raise the loop
output (displayed as %).
Increase or decrease
Setpoint value
Access the loop tuning
parameters
Interacting with Alarm Summary
Refer to section 7.4 Access Summaries for details.
228
Table 6-7 Interacting With Loop Displays (continued)
Press Tab key to move cursor to loop output. To change the output, the loop
must be in manual mode (initiated by front panel key or by external discrete
signal)– not in Remote Manual mode.
Press Tab key until cursor is on the setpoint value. Press Up Arrow and Down
Arrow to adjust value. Only numerically assigned setpoint values can be
changed online; Setpoint #2 cannot be changed if it is acting as a remote
setpoint (e.g. running a profile).
You can also change the setpoint value by accessing the Tune Loop menu as
described in the next row.
Press Tab key until the cursor is on the loop tag at the top of the display. Press
Enter to access the Tune Loop menu for that loop. Adjust desired parameters.
To return to the loop display, press Menu. See Section 7.7 Tune Loop.
ALARM SUMMARY
PAGE 4
PROCESS 1
TEMP 7
01:12:59
PROCESS 1
TEMP 8
01:12:59
PROCESS 3
TEMP 9
01:12:59
A D DISK FULL
Figure 6-8 Alarm Summary Display
VPR & VRX – User Manual
Do these steps
14:25
HIGH
CURR=1234.56
04/12/97
LOW
CURR=2345.54
04/12/97
HRATE
CURR=1234.56
04/12/97
12/00
Advertisement
Table of Contents
