Table 5-1 Example Of Segment Events; Figure 5-8 Activating Events In Mid-Segment - Honeywell VPR100 User Manual

Setpoint Profiler
Segment Events
Each segment contains 16 programmable discrete event outputs whose ON/OFF states- specified by you -
can be used to trigger other discrete functions. The segment's event states are activated at the beginning of
the segment and are maintained unless changed by the next segment in the profile. See Table 5-1. The last
segment's event states are maintained after the profiler is ended.
Event 1 State
Event 2 State
Event 3 State
To activate events in the middle of a ramp segment, replace the desired segment with 3 segments: a ramp, a
very short soak, and another ramp. Program the second and third segment events as if they were the middle
of the segment.
192

Table 5-1 Example of Segment Events

Segment #1
1 (ON)
0 (OFF)
1 (ON)
To activate events here
Program this:

Figure 5-8 Activating Events In Mid-Segment

VPR & VRX – User Manual
Segment #2
0 (OFF)
1 (ON)
0 (OFF)
Ramp segment
Same events as short soak
Short soak segment
with desired events
Ramp segment
Program both ramps with same slope.
Segment #3
0 (OFF)
0 (OFF)
1 (ON)
12/00