Table 4-3 Labels For Function Blocks - Honeywell VPR100 User Manual

Prompt
DESCR
TAG
UNITS
ON STATE
OFF STATE
12/00

Table 4-3 Labels for Function Blocks

Range/Selections
Enter 16 characters maximum.
Enter 7 characters maximum.
Default choices:
PSI DEGR GAL
BAR K LPH
MW MV LPM
GPH V LPS
GPM OHM LITR
GPS HZ DEGC
DEGF
OFF ON FILL
UP DOWN EMPTY FULL
START STOP IN
LOW HIGH OPEN CLOSED
RESET RUN HOLD
TRUE FALSE READY ABORT
LEFT RIGHT ALARM NORMAL
DECRS INCRS AUTO MANUAL
LOAD UNLOAD SP1
COOL HEAT NO
PAUSE
See ON STATE for default choices.
VPR & VRX – User Manual
Programming Function Blocks and Features
Called a descriptor. Usually appears as a
header or title on some displays and
reports. For alarms, this is the actual
alarm message. If labeling is enabled, the
descriptor can be edited in the function
block's program menu.
Identifies the point or function on most
displays and reports. Each tag must be
unique. If labeling is enabled, the tag can
be edited in the function block's program
menu.
Shows units of measure for analog values
MA on most displays and reports. This list of
units can be changed under the
%
ENGINEERING UNITS menu item. If
PH
labeling is enabled, the units can be
KG
edited in the function block's program
GRAM
menu.
LB
DRAIN
Select a label describing the ON(1) state
of the discrete function. These labels can
not be changed.
OUT
ACTIVE
SP2
YES
Select a label to describe the OFF (0)
state of the discrete function. These
labels can not be changed.
Definition
83