Frequently Used Programming Prompts; Table 4-2 Frequently Used Programming Prompts - Honeywell VPR100 User Manual

Programming Function Blocks and Features

4.4 Frequently used programming prompts

When programming the instrument you will see certain prompts repeatedly in different menus. These are
described in Table 4-2, rather than in each menu in which they appear.
Prompt
IN DECIMAL POS
OUT DECIMAL POS
ON LABEL*
OFF LABEL*
DESCR*
TAG*
UNITS*
* Prompt does not appear if labeling is disabled under ENABLE FEATURES.
80

Table 4-2 Frequently Used Programming Prompts

Range/Selections
X.XXXXX XXXX.XX
XX.XXXX XXXXX.X
XXX.XXX XXXXXX.
X.XXEXX
Same as IN DECIMAL POS selections
OFF ON FILL
UP DOWN EMPTY FULL
START STOP IN
LOW HIGH OPEN CLOSED
RESET RUN HOLD
TRUE FALSE READY ABORT
LEFT RIGHT ALARM NORMAL
DECRS INCRS AUTO MANUAL
LOAD UNLOAD SP1
COOL HEAT NO
PAUSE
Same as ON LABEL selections
Enter up to 16 characters.
Enter 7 characters maximum.
Default choices:
PSI DEGR GAL
BAR K LPH
MW MV LPM
GPH V LPS
GPM OHM LITR
GPS HZ DEGC
DEGF
VPR & VRX – User Manual
Select the decimal point position to be
used for all inputs to the function.
Select X.XXEXX to display the function's
values in exponential notation.
Example: 1.23E4 means 1.23 x 10
Select the decimal point position that will
be used for all outputs of the function.
DRAIN Select the discrete function's ON(1) state
label.
OUT
ACTIVE
SP2
YES
Select the discrete function's OFF state
label.
Usually appears as a header or title on
some displays and reports. For alarms, this
is the actual alarm message.
Identifies the point or function on most
displays and reports. Each tag must be
unique.
Shows units of measure for analog values
on most displays and reports. These 25
MA
choices can be changed. See Table 4-4.
%
PH
KG
GRAM
LB
Definition
4
.
12/00