Transmission End Crankshaft Seal Installation-In Car - Honda Civic 2002-2003 Service Manual

Engine Block
Oil Pan Installation (cont'd)
6. II the engine is still in the vehicle, install the
sublrame.
-1 Install the sublrame. Align the relerence lines
on the sublrame with the bolt head center, then
tighten the bolts (see step 5 on page 5-10).
-2 Tighten the lront mounting bolt (see step 6 on
page 5-10).
-3 Tighten the rear mount mounting bolts (see
step 7 on page 5-11).
-4 Connect the suspension lower arm ball joints
(see step 6 on page 18-19).
7. After assembly, wait at least 30 minutes belore
lilling the engine with oil.
7-28
Transmission End Crankshaft Seal
Installation - In Car
Special Tools Required
• Driver 077 49-00 1 0000
• Oil seal driver attachment 96 07ZAD-PNAA 100
1. Dry the crankshaft oil seal housing.
2. Use the special tools to drive a new oil seal
squarely into the block to the specilied installed
height.
07ZAD-PNAA 100
3. Measure the distance between the crankshaft
(A)
and oil seal
(8).
Oil Seal Installed Height:
5.5-6.5 mm 10.22-0.26 in.)
~i
-...-- 5.5-6.5 mm
10.22-0.26
in.!
\...".