Interdigit Short Timer (Complete Entry Timer); Edit The Dial Plan On The Ip Phone - Cisco 8800 Series Administration Manual

Cisco IP Phone Installation
Example for the Interdigit Long Timer
L:15, (9,8<:1408>[2-9]xxxxxx | 9,8,1[2-9]xxxxxxxxx | 9,8,011xx. | 9,8,xx.|[1-8]xx)
L:15 means that this dial plan allows the user to pause for up to 15 seconds between digits before the Interdigit
Long Timer expires. This setting is especially helpful to users such as sales people, who are reading the
numbers from business cards and other printed materials while dialing.

Interdigit Short Timer (Complete Entry Timer)

You can think of this timer as the complete entry timer. This timer measures the interval between dialed digits.
The timer applies when the dialed digits match at least one digit sequence in the dial plan. Unless the user
enters another digit within the specified number of seconds, the entry is evaluated. If the entry is valid, the
call proceeds. If the entry is invalid, the call is rejected.
Default: 3 seconds.
Syntax for the Interdigit Short Timer
SYNTAX 1: S:s, (dial plan)
Use this syntax to apply the new setting to the entire dial plan within the parentheses.
SYNTAX 2: sequence Ss
Use this syntax to apply the new setting to a particular dialing sequence.
s: The number of seconds; if no number is entered after S, the default timer of 5 seconds applies.
Examples for the Interdigit Short Timer
To set the timer for the entire dial plan:
S:6, (9,8<:1408>[2-9]xxxxxx | 9,8,1[2-9]xxxxxxxxx | 9,8,011xx. | 9,8,xx.|[1-8]xx)
S:6 means that while the user enters a number with the phone off hook, the user can pause for up to 15 seconds
between digits before the Interdigit Short Timer expires. This setting is especially helpful to users such as
sales people, who are reading the numbers from business cards and other printed materials while dialing.
Set an instant timer for a particular sequence within the dial plan:
(9,8<:1408>[2-9]xxxxxx | 9,8,1[2-9]xxxxxxxxxS0 | 9,8,011xx. | 9,8,xx.|[1-8]xx)
9,8,1[2-9]xxxxxxxxxS0 means that with the timer set to 0, the call is transmitted automatically when the user
dials the final digit in the sequence.

Edit the Dial Plan on the IP Phone

Note
You can edit the dial plan in the XML configuration file. Locate the
configuration file, where n denotes the extension number. Edit the value of this parameter. The value must
be specified in the same format as in the Dial Plan field on the phone administration web page, described
below.
Cisco IP Phone 8800 Series Multiplatform Phones Administration Guide
Example for the Interdigit Long Timer
parameter in the XML
Dial_Plan_n_
77