Table of Contents
Advertisement
Chapter 2
Module Installation
Preparing for Installation
Before you begin, make sure that the module is in good condition and that
you have the tools and equipment listed here.
Unpacking and Inspecting the Module
As you unpack the module, inspect it for shipping damage. If you find any
damage, contact Cisco Services. Refer to Customer Information (on page 91)
for contact information.
Equipment and Tools Needed
Before you begin, make sure that the module is in good condition. You need
the following equipment and tools to install these modules.
You need . . .
A standard Prisma II Chassis with power
supply
A 3/8-in. flat-blade screwdriver
A 7/16-in. open-end wrench
One RF cable with connectors
14
To . . .
Provide housing, power, and input and
output connections to the module.
Secure the module in the chassis.
Secure RF cable connectors at the chassis.
Carry RF input signals.
Advertisement
Table of Contents
Troubleshooting
