High Density Long Reach Multiwave And Hybrid Modulation Qam Transmitter Parameters; Operating Status Parameters - Cisco Prisma II HD-LRMW Installation And Operation Manual

Appendix A
Module Parameter Descriptions
High Density Long Reach Multiwave and Hybrid
Modulation QAM Transmitter Parameters

Operating Status Parameters

Parameter
Name (LCI)
RF Input
Optical Output
Power
Module
Temperature
Laser
Temperature
TEC Current
Laser RF Drive
Laser Enable
Low RF Alarm
Inhibit
Master
RF Drive Level
AGC
Length
Dither
Laser Bias
SBS 2 GHz PLL
SBS 2 GHz
Power
ITU
Note:
94
ICIM Function
Abbreviation
InRF Displays relative RF input power.
OutPwr Displays HD-LRMW optical output
power
Displays HQT optical output power
ModTemp Displays module temperature.
LasTemp Displays laser temperature.
TecCur Indicates laser thermoelectric cooler
current. A positive value indicates
cooling; a negative value indicates
heating.
RF drive level at laser input reference to
LasRF
nominal setup.
Enable Laser on/off.
LoRFInh Low RF alarm enabled/disabled.
Master Master or Slave operation.
RFDrive RF drive level reference to nominal
setup.
AGC Automatic Gain Control.
FibLinDi Displays distance setting in kilometers.
Dither Displays dither On/Off (usually Off).
LasBias Displays measured laser bias current.
SbsStat SBS phase lock loop (PLL) lock status
(Lock or Fault).
Psbs2G Indicates 2 GHz SBS power.
ITU Displays ITU channel designator
Typical
Value
0 dB
+12.5 dBm
+11.5 dBm
Ambient °C
+ 15 °C
30 °C
0.20 A
-1.5 dB
-
-
-
0.0
-
50 km
-
0.270 A
Lock
10.0 to 400.0
N/A