Operation Using The Icim - Cisco Prisma II HD-LRMW Installation And Operation Manual

3 Chapter 3

Operation Using the ICIM

Introduction
The procedures in this chapter apply if you are using the Prisma II
ICIM2 front-panel interface to configure and operate the module. For
information on using CLI commands or the ICIM Web Interface to
configure and operate the module, see the Prisma II Platform Remote
User Interface Guide, System Release 2.03.
Scope of This Chapter
Included in this chapter are descriptions of the ICIM2 front-panel
keyboard and liquid crystal display (LCD), and detailed procedures
on how to use front-panel menus to configure the module.
Note: You must use CLI commands or the ICIM Web Interface to
configure and operate the module when using the ICIM2-XD. For
details, see the Prisma II Platform Remote User Interface Guide, System
Release 2.03.
In This Chapter
¡
ICIM Introduction .............................. Error! Bookmark not defined.
¡
ICIM2 Front Panel .............................. Error! Bookmark not defined.
¡
ICIM Password ................................... Error! Bookmark not defined.
¡
Operating the ICIM ............................ Error! Bookmark not defined.
¡
Checking the Operating Status using the ICIMError! Bookmark not defined.
¡
Configuring the Module using the ICIMError! Bookmark not defined.
¡
Checking Module Alarms using the ICIMError! Bookmark not defined.
¡
Checking Manufacturing Data using the ICIMError! Bookmark not defined.
¡
Saving the Configuration using the ICIMError! Bookmark not defined.
¡
Adjusting Alarm Thresholds............. Error! Bookmark not defined.
37