Module Configuration; Configuration And Monitoring Methods; Configuration Summary - Cisco Prisma II HD-LRMW Installation And Operation Manual

Module Configuration

The transmitter ships from the factory with operational parameters set to
factory defaults. However, you may choose to configure the operating
parameters so that they are best suited for your application.

Configuration and Monitoring Methods

The module may be controlled and monitored using any of the following
methods.
Prisma II ICIM Front Panel
¾
When a standard Intelligent Communications Interface Module 2 (ICIM2) is
used, its front-panel LCD and keypad interface can be used to configure and
monitor this and other Prisma II modules in the ICIM domain. For instructions
on operating this module using this ICIM, refer to Operation using ICIM (on
page 37).
LCI Software
¾
Local Craft Interface (LCI) software running on a locally connected PC may be
used to configure operating parameters of Prisma II modules. For instructions
on operating this module using LCI software, refer to Operation using LCI (on
page 63).
CLI Commands
¾
If an ICIM2 or ICIM2-XD is installed, command line interface (CLI) commands
enable communication between the ICIM and the operator over Telnet to
allow for remote module setup and monitoring. For details, see the Prisma II
Platform Remote User Interface Guide, System Release 2.03, part number 4025477.
ICIM Web Interface
¾
The ICIM Web Interface offers a user-friendly alternative to CLI commands
for remote module setup and monitoring using an ICIM2 or ICIM2-XD. Users
navigate a series of HTML pages through a standard web browser to view and,
where permitted, adjust module parameters. For additional information, see
the Prisma II Platform Remote User Interface Guide, System Release 2.03, part
number 4025477.

Configuration Summary

You can use any of the methods listed above to perform the following
configuration tasks:
Enable or disable transmitter operation
¾
Module Configuration
11