Preparing For Installation; Equipment And Tools Needed; Unpacking And Inspecting The Module - Cisco Prisma II EDR Installation Manual

Chapter 2 System Installation

Preparing for Installation

Before you begin, make sure that the module is in good condition and that you have
the tools and equipment listed here.

Equipment and Tools Needed

Before you begin, make sure that the module is in good condition. You need the
following equipment and tools to install the module.
You need . . .
A Prisma II or Prisma II XD Chassis with
power supply
3/8-in. flat-blade screwdriver
Optical cables with connectors
Optical cleaning materials
Optical power meter
Spectrum analyzer (for transmitter)

Unpacking and Inspecting the Module

As you unpack the module, inspect it for shipping damage. If you find any damage,
contact Cisco Services. See Customer Information (on page 39) for contact
information.
18
To . . .
Provide housing, power, and input/output
connections to the module.
Secure the module in the chassis.
Carry optical input and output signals.
Clean optical connectors.
Verify optical input and output levels.
Verify proper RF input.
OL-32414-01