Panasonic DVC PRO Studio AJ-D950P Service Manual page 89

9. After adjustment, turn POWER switch "ON" and "OFF", and confirm
that the H Phase position is stable.
6.3.10. SYSTEM_H,SYSTEM_SC
Board
Specification
Test Point
Adjustment Point
Input Signal
Mode
Tape
M.EQ
1. Place the unit in the 625 mode.
2. SYSTEM MENU SETTING
SYS H : 0
SYS SC : 0
3. WFM/VSC
MODE : VSC
REF : EXT mode
INPUT : CHA
4. Set the CHA Burst Phase to 0°.
5. Change the INPUT SELECT to CHB.
6. Adjust VR16 so that the Burst Phase is 0°.
7. WFM/VSC
MODE : WFM
REF : EXT mode
INPUT : CHB
8. Adjust VR4 so that the H Sync Phase as close as the CHA H Sync
Phase.
9. After adjustment, turn POWER switch "ON" and "OFF", and confirm
that the H Phase position is stable.
6.3.11. COMPOSITE OUT DC LEVEL ADJ.
V_OUT (F6)
VIDEO OUT 1
V PHS P, VR16 (D-1) VR4
(A-2)
REF_IN, = BB (PAL)
EE, INT SG
Oscilloscope, WFM / VSC
89