Table of Contents
Advertisement
5.6.2. Pinch Solenoid Position Adjustment
Specification
Test Point
Adjustment
Mode
Tool
1. Turns power off.
2. Close the pinch roller to the capstan shaft.
3. Press the pinch solenoid by your hand and touch the pinch roller
with the capstan shaft.
4. Loosen the 2 screw A and adjust B portion so that the Gap T is in
the specification by VFK0357.
5. Tighten the 2 screw A after adjustment.
T = 0.3mm
Space at T portion
A, B
EJECT (Power Off)
VFK0357 (Eccentric Driver)
17
Advertisement
Chapters
Table of Contents
