Panasonic DVC PRO Studio AJ-D950P Service Manual page 436

<Connector area>
q AC IN connector
w SIGNAL GND terminal
e Fuse holder
r Fan motor
t TIME CODE IN connector
y TIME CODE OUT connector
u CUE IN connector
i CUE OUT connector
o MONITOR OUT connector
!0 ANALOG AUDIO IN connectors
!1 ANALOG AUDIO OUT connectors
!2 SDTI IN/OUT connector (option)
!3 ANALOG COMPONENT VIDEO IN connector (option)
!4 ANALOG COMPOSITE VIDEO IN connectors and 75Ω termination switch (option)
!5 REF VIDEO IN connectors and 75Ω termination switch
This is for connecting the unit to the power outlet using the power cord provided.
This terminal is connected to the signal ground terminal of the connected unit in order to
reduce noise. It is not connected to ground for safety purposes.
This contains a fuse.
This is for cooling the unit.
The W lamp lights when trouble has caused the fan motor to stop. If the unit is still
operated in the warning status, the temperature inside the deck will rise, and when it
exceeds the safety temperature, all the unit's operations will be shut down.
This is the connector for recording the external time code on the tape.
The playback time code is output from this connector during playback.
During recording, the time code generated by the internal time code generator is output.
The analog signal to be recorded on the CUE track is supplied to this connector. The
audio signals from a microphone can also be recorded by selecting the –60dB input mode
on the setup menu No. 705 (CUE IN LV).
The analog signal recorded on the CUE track is output from this connector.
During playback, the playback signals from the CUE track or PCM audio signal CH1/CH2/
CH3/CH4 are output from this connector.
These are the analog audio input connectors.
The analog audio signals are output from these connectors.
The analog component video signal is supplied to this connector.
The analog composite video signal is supplied to these two connectors which are
connected in a loop-through configuration. When the termination is required, set the
switch to ON.
These are the input connectors for the reference video signals. Supply signals with colour
burst. When the termination is required, set the switch to ON.
– E-18 –