Table of Contents
Advertisement
(Adjustment Procedures)
1.
Install a MIC Intermittent Gear.
2.
Set the Reel Rotor Unit at M Cassette Position by
hand.
3.
Install a MIC Drive Arm Unit.
4.
Rotate the MIC intermittent Gear by hand so that the
Distinction SW is as close as possible.
Gear Position
5.
Install a Reel Drive Cam Gear so that the its hole is
at MIC intermittent gear hole.
6.
Install 3 cut washers (A), (B) and (C).
Adjustment Note:
1)
Close the Reel Table to M Cassette position.
2)
Set the MIC SW (Distinction SW) to the nearest
position from the Reel.
3)
MIC Drive Arm Unit Pin position is as shown in the
above figure.
4)
Reel Drive Came Gear Hole and MIC Intermittent
Gear phase are matched.
3-7-29. T4 Post Position Adjustment
1.
Set the VTR unloading condition.
2.
Confirm the T4 post hole is at the T4 connection
gear (B).
3.
Confirm that © and hole (A) position is as shown in
the figure.
4.
If the T4 post position is incorrect adjust following
procedures.
Hole (A)
T4 Post
T4 Connection Gear
T4 Post Position Adjustment
(C)
Hole (B)
Advertisement
Chapters
Table of Contents
