Table of Contents
Advertisement
5.7.30. Thrust Screw Replacement and Adjustment
1. Remove the Thrust Screw.
2. Supply oil (VFK0906) as shown in the figure and set the capstan
housing.
3. While rotating the capstan shaft CCW tighten the thrust screw CW
slowly and stop it when the rotation becomes smoothly.
4. Rotate another 180 degrees or 270 degrees from the stop position
of item 3.
5. Grew the thrust screw.
6. Confirm the oil seal as shown in figure.
T4 Post Position Adjustment
79
Advertisement
Chapters
Table of Contents
