.
3-6-2
Pinch Solenoid Position Adjustment
Specificatio
T = 0.3mm
Test Point
Space at T portion
Adjustment
A, B
Mode
EJECT (Power Off)
Tool
VFK0357 (Eccentric Driver)
1.
Turns power off.
2.
Close the pinch roller to the capstan shaft.
3.
Press the pinch solenoid by your hand and
touch the pinch roller with the capstan shaft.
4.
Loosen the 2 screw A and adjust B portion
so that the Gap T is in the specification by
VFK0357.
5.
Tighten the 2 screw A after adjustment.
Plate C
Plate D
Plate C
Gap T
Gap T
Spring Z
Plate D