Panasonic DVC PRO Studio AJ-D950P Service Manual page 936

1-2-5.COMPONENT
BOARD F6 SUB
SPEC. 0V ± 50mV
TEST POINT Y-OUT
ADJ. VR3007
INPUT SDI IN 100% CB 0% SETUP
MODE EE
TAPE
M.EQ OSCILLOSCOPE (DC mode)
1. Adjust VR3007 so that the Y clamped pedestal
level is at scope GND level.
    
     


CLAMP LEVEL ADJ.
    
1-2-6.COMPONENT Pb CLAMP LEVEL ADJ.
BOARD F6
0V ± 50mV
SPEC.
TEST POINT Pb_OUT
ADJ. VR3009
INPUT SDI IN 100% CB 0% SETUP
MODE EE
TAPE
M.EQ OSCILLOSCOPE (DC mode)
1. Adjust VR3009 so that the Pb clamped pedestal
level is at scope GND level.