Panasonic DVC PRO Studio AJ-D950P Service Manual page 27

5.6.15. A/C Head ADJUSTMENT Method (summary)
Item Screw
Tilt Adjustment A
Height B
Adjustment
Azimuth F
Adjustment
A/C Head C
Horizontal
D
Position Adj.
Tilt G
Height Fix H
Screw
A
B
F
C, D, G
H
1. Each Adjustment must be done keeping the screw G tighten.
2. When tilt is adjusted, confirm the screw A is tighten. (A/C Head
must be touch with the fix plate.)
3. When tilt is adjusted confirm that there is no tape damage at T3
Post.
Adjustment
CW --- Decrease CUE Level
CCW --- Increase CUE Level
CW --- If the level is increased at "k".
CCW --- If the level is increased at "j".
Adjust phase by the screw F.
Adjust A/C Head Horizontal Position by VFK0357
(Eccentric Driver) at long hole E, then tighten the
screw C and D.
Adjust by tightening the screw except tilt and
azimuth adjustment.
After the Height Adjustment, tighten screw H to fix
the A/C Head Height.
Tool
VFK1178 (0.89 mm Nut Driver)
VFK1150 (5.5 mm Nut Driver)
VFK1148 (1.5 mm Nut Driver)
VFK1209 (Torque Driver)
VFK0912 (1.5 mm Hex Driver Bit)
VFK1190 (1.5 mm L type Hex Wrench)
27
Torque
(Adjustment)
(Adjustment)
(Adjustment)
2.5 Kg/cm
1.0 Kg/cm