Table of Contents
Advertisement
Specification
Test Point
Adjustment
Mode
Tape
M. EQ.
Tool
1. Playback the alignment tape CUE audio 6 kHz portion.
2. Connect a scope to TP101 and raise the A/C head or push down it
to confirm the CTL level is not increased.
3. If it is increased, slightly adjust the "A/C Head Height Adjustment"
and confirm the CTL level is correct.
4. If A/C Head Height is changed the azimuth is changed also.
Therefore A/C Head azimuth must be adjusted and confirm
alternately.
5. When A/C Head Height is fixed, tilt is changed by tightening screw
H and the height is changed. Therefore Height confirmation must
be done after tightening screw H.
A=0.95 × Amax or more
C1, C2 = 1.8V or more
TP101 CUE AUDIO(CUE:H1)
TP30 CTL(SERVO:F1)
Screw B, H (A/C Head)
PLAY
VFM3580KM (No.1)
Oscilloscope
VFK1150,VFK1190(Hex Wrench)
33
Advertisement
Chapters
Table of Contents
