List Of Faults And Alarms - Siemens Sinumerik 840D sl Function Manual

Diagnostics
10.3 Safety messages for SINAMICS S120
The optional brackets indicates whether the type specified for this message can be
changed and which message types can be selected via parameter.
Information about the response and acknowledgment are independently specified
for a message with adjustable message type (e.g. response to F, acknowledgment
for F).
10.3.2

List of faults and alarms

Note
S In the HMI environment, faults and alarms are displayed specifying a six--digit
number that always starts with 2. For example, this means that F01600 is then
called 201600. In this Chapter, faults and alarms are described with numbers
from the SINAMICS environment.
S In the HMI environment, faults and alarms are treated like alarms.
List of faults (Control Unit)
F01600
Response
Acknowledgment
Explanation
Remedy
10-744
SINUMERIK 840D sl/SINAMICS S120 SINUMERIK Safety Integrated (FBSI sl) - - 10.2015 Edition
SI P1 (CU): STOP A initiated
OFF2
IMMEDIATELY (POWER ON)
The "Safety Integrated" function integrated in the drive on the Control
Unit has detected a fault and initiated a STOP A (STO via the safety
shutdown path of the Control Unit).
-- Forced checking procedure of the safety shutdown path of the
Control Unit unsuccessful.
-- Subsequent response to fault F01611 (defect in a monitoring
channel).
Fault value (r0949, interpret decimal):
0: Stop request from monitoring channel 2
1005: STO active, although STO not selected and there is no internal STOP
A present.
1010: STO inactive although STO is selected or an internal STOP A is
present.
9999: Subsequent response to fault F01611.
Select safe standstill and then deselect again.
-- Replace the Motor Module involved.
For fault value = 9999:
-- Carry out diagnostics for fault F01611 that is present.
© Siemens AG 2015 All Rights Reserved
10/15