Siemens Sinumerik 840D sl Function Manual page 739

10/15
r Program
continuation
27811
Parameter
Explanation
Response
Remedy
r Program
continuation
27813
Parameter
Explanation
© Siemens AG 2015 All Rights Reserved
SINUMERIK 840D sl/SINAMICS S120 SINUMERIK Safety Integrated (FBSI sl) - - 10.2015 Edition
Switch control system OFF and ON again.
Axis %1: Parameterizing error: MD %2[%3] invalid
%1: Axis name, spindle number
%2: MD name
%3: MD field index to the MD name
The parameterization of the displayed machine data is incorrect.
This alarm occurs in the following contexts:
-- When evaluating the SIC/SCC telegram number in MD13376
$MN_SAFE_INFO_TELEGRAM_TYPE or in drive parameter
p60122, an invalid SIC/SCC telegram number was identified (not
equal to 701)
-- Checking the logical basis addresses from MD13374
$MN_SAFE_INFO_DRIVE_LOGIC_ADDR has shown that a slot
with this address does not exist or the SIC/SCC telegram has an
incorrect length and the SIC/SCC communication cannot be
enabled.
-- Checking the logical basis addresses from MD13372
$MN_SAFE_PS_DRIVE_LOGIC_ADDR has shown that a slot with
this address does not exist and PROFIsafe communication cannot
be enabled.
Alarm display
NC start disable in this channel
Interface signals are set
Mode group not ready
NC Stop on alarm at end of block
Channel not ready
Stop cyclic SIC/SCC or PROFIsafe communication between the NCK
and drive.
Parameterize a valid SIC/SCC with telegram number (701)
Configure or parameterize using valid logical basis addresses for the
SIC/SCC slots or PROFIsafe slots
Switch control system OFF and ON again.
Option "F- -Logic" not set, MD: "%1" error
%1: MD name
Option for F logic MD19500 $ON_SAFE_PLC_LOGIC not available.
The safety operating mode "SINUMERIK Safety Integrated plus
(F--PLC)" is set in MD13370 $MN_SAFE_MODE.
10.2NCK safety alarms for Sinumerik 840D sl
Diagnostics
10-739