Panasonic LP-V Series Operation And Maintenance Manual page 73

Notice
• Connect the head and controller combined for the same serial number.
• For the connection of this product, use the dedicated cables attached to the product or the specified optional cables.
• Do not connect the Head Control Cable to the I/O Connector. It may cause a failure.
• Insert the cables all the way in a straight line. Tilting and inserting the cable may cause a failure.
Reference
• Connect the terminal block wiring [IN COM.], [OUT COM], [LASER STOP +] and [EMER. +] with proper connection
respectively.
The laser pumping and marking cannot start without connecting them.
⿎ Cable Wiring for LP-400 series Tower Head
For LP-43xTU / LP-42xS9TU / LP-43xTU-C / LP-42xS9TU-C / LP-43xTU-CHN / LP-42xS9TU-CHN model, connect the
cables using the banding band and banding base as shown below figure.
Notice
• Do not place the cables over the exhaust vent. It may cause the malfunction.
ME-LP400V-OP-6
73