⿎ LP-V/LP-W Series
[LP-VxxU / LP-VxxU-A / LP-VxxU-C / LP-W052U / LP-W052U-A]
8
1.
Signal Connector: SIGNAL
This is the terminal for communicating between head and controller.
Connect the attached head control cable.
2.
Power Connector: POWER
This is the connector for supplying the power to the head.
Connect the attached head power cable.
3.
Laser Radiation Indicator
This indicator indicates the laser radiation state. Refer to Refer to "Safety Functions on Laser Marker" (P.27) for the
detail.
4.
Laser Pointer Emission Port
The emission port of the red laser pointer radiated when using the dual pointer function. To use the dual pointer
function, do not seal the laser pointer emission port at the installation. For details, refer to "2-1-7 Lasing position
check" (P.69).
5.
Laser Emission Port
This is the emission port of the laser beam.
6.
Focus Dial
This is the dial to check the focus adjusting. Refer to Refer to "2-1-8 Focus adjustment function" (P.70) for the detail.
7.
Focus Adjusting Control
The control for adjusting the distance from the work. Refer to Refer to "2-1-8 Focus adjustment function" (P.70) for the
detail.
3
6
7
5
4
ME-LP400V-OP-6
10
9
1
2
51