Description
10
X/Y Position :
Inputs the coordinate value of X or Y axis. Press the numerical value to display a ten-key pad.
11
X/Y Position Fine Adjustment :
Fine-adjusts the target marking contents to up/down or right/left direction. (in 0.001mm pitch)
*1 : Displayed only with the setting for marking of flying object.
4-14-2 Work Image Display
In case there are data which you will see on the image display, but not be marked, such as the outline data of the marking
object or characters, setting 0% to "Laser Power Correction". Then, the data are showed with gray figure on the image
display.
The marking data which are set to 0% for "Laser Power Correction" are not marked. They do not affected the marking time
etc. as well.
Reference
• When "Laser Power Cor." is set to 0%, these character, logo, barcode or processing data are not traced with the guide
laser "Marking Character" mode.
240
ME-LP400V-OP-6