Installation Of Lp-V / Lp-W Head - Panasonic LP-V Series Operation And Maintenance Manual

2-1-4 Installation of LP-V / LP-W Head

WARNING
⿎ Installation Method and Direction
• LP-V10U / LP-W052U: The head can be fixed from the bottom with M6 screw at 10 locations.
• LP-V15U: The head can be fixed from the bottom with M6 screw at 6 locations.
• For the installation dimension, refer to "1-4 Outer Dimensional Drawing" (P.40).
• Install the head on a plate with a thickness of 10 mm to 15 mm which is made of aluminum or other material with
radiation performance equivalent to that of aluminum.
• Tightening torque: 3.0 N·m or less.
• The inserting length of the screw shall be 5 mm to 6 mm.
M6 screw
Notice
• Do not incorporate the laser marker in a unit where the laser head will be moved. It may cause failure.
• When install the head with the lens side up, clean the laser emission port and remove the marking dust regularly.
• Check the length of the screw and install it. Using improper screws and forcibly tightening them might damage the
product.
• Install the product so that the laser beam path does not cross the eye height.
• The laser beam path shall be enclosed with protective enclosure and make sure
it is not exposed with direct light or reflected light.
Laser marker
5 to 6 mm
Washer thickness + stand thickness
* For LP-V / LP-W series, the plastic lens cap
is attached at shipping. Be sure to remove it
before use.
ME-LP400V-OP-6
Lens cap*
65