Panasonic LP-V Series Operation And Maintenance Manual page 192

Description
7 Check Character :
Setting this check character function inputs the following check character automatically.
• CODE 39: modulus 43
• ITF: modulus 10/weight 3-1
• NW-7: modulus 16
Reference
• For CODE 128, inputting "FNC1" and "01" at the head of the bar code data followed by 13-figure numeric automatically
input one check digit (modulus10/weight 3-1).
• For 1D of Composite whose lower bar code consists of UCC/EAN128, inputting "01" at the head of the bar code data
followed by 13-figure numeric automatically input one check digit (modulus10/weight 3-1).
8 Start / Stop Character (NW-7 only) :
Specifies the start/stop character.
Select from "A", "B", "C" or "D".
9 Human Readable Text (only for CODE128 / EAN / UPC) :
Sets "Human Readable Text" marking for EAN / UPC, CODE 128 and UCC/EAN128. Check the box to enable the
function.
Reference
• For the settings of the human readable text of CODE128 and UCC/EAN 128, refer to "Human Readable Text" (P.203).
• For EAN / UPC code, the human readable text is marked with the font registered in character font 1 and with the
specified text size and position according to the code standard.
• For EAN / UPC code, if the laser power correction value of the code symbol is set 0, the human readable text is not
marked.
10 Bar Code Data :
Specifies the data to be Bar Code.
Refer to "Code Type and Code Data" (P.190) for the available characters.
192
ME-LP400V-OP-6