4-16-5 Output Simulation
With the output simulation you can check the output signals of the laser marker without an actual operation.
Use this function to confirm the operation of the external devices connected with the laser marker.
3
Item
1
I/O Terminal
2
I/O Connector
3
Output ON/OFF
4
STOP OUTPUT
Reference
• For the name of each signal, refer to "External Control Manual".
1
Description
:
In the table, the status "0" indicates output OFF and "1" indicates output ON.
During the output simulation, the status display of the terminal changes to yellow.
:
Click the output terminal name to simulate, then the output status of the laser marker
changes.
:
Terminates the simulation mode and reset the ON/OFF status of the output signals.
This button appears when output simulation is started.
During the output simulation, other operation and settings are disabled.
ME-LP400V-OP-6
2
4
267