Specifying The Key Output Destination - Sony DVS-9000 User Manual

Note
In setup (Engineering Setup >Switcher >Device Interface menu), if "Up to
3Keys" is selected, the second channel video signal is also selected on the AUX
bus.
For details, see "Interfacing With External Devices (Device Interface Menu)"
in Chapter 19 (Volume 3).
You can check the DME operating status in the Status menu (see page 415).
Assigning a DME output signal as a monitor signal
1
In the Processed Key menu, press [Monitor].
The Monitor menu appears.
2
Press [Monitor Set], turning it on.
3
In the <DME Select> group, select the DME channel (DME1 to DME8) to
be used.
This assigns the selected DME output to DME MON V and DME MON K.
The colors with which [DME1] to [DME8] are lit show the key assignment
status.
Lit green: DME currently being monitored
Lit amber: DME that can be monitored
Off: Unassigned DME

Specifying the Key Output Destination

Using the key processed keyer signals (external processed key)
To select the key processed keyer key fill and key source signals on the AUX
bus or edit preview bus, press [Ext Proc Key] turning it on, in the Processed
Key menu.
This assigns the key fill and key source signals for M/E-1 key 1 to reentry
signals PROC V and PROC K.
When a DME is selected on the keyer, the key fill and key source signals to
which a DME effect is applied are assigned.
Note
You cannot select the PROC V and PROC K signals using the cross-point
selection buttons of the M/E or PGM/PST bank.
Key Setting Operations Using Menus
235