You can also use the Transition menu to select a desired independent key
transition type for each key (see the next section).
For details of the wipe settings, see "Wipe Settings for Independent Key
Transitions" (page 293). For details of DME wipe settings, see "DME
Wipe Settings for Independent Key Transitions" (page 334).
3
Execute the transition.
To insert or delete the key gradually with a mix or wipe transition:
Press the [AUTO TRANS] button.
For details of the transition rate, see "Setting the Independent Key
Transition Rate" (page 189).
For details of operation together with a common transition, see
"Combining other transitions with independent key transitions" (page
183).
To cut the key in or out instantaneously: Press the [KEY ON] button on
the keyer.
Notes
• In an independent key transition, the pattern limit function is not
available.
• When the following DME effects are set, the effects may be applied
during wipe transitions. If the effects are not necessary, cancel the
settings.
– Trail
– Motion Decay
– Wind
When the Keyframe Strobe effect is set, operating keyframes do the
same effect. Cancel the unnecessary settings.
Independent Key Transitions
187