Sony DVS-9000 User Manual page 171

If required, press the [TC] button to toggle the input mode (frame input or
timecode input).
• Enter a value of up to three digits.
• To clear the entry, press the [CLR] button.
4
Press the [ENTER] button.
This confirms the entry, and the selected region name and the set transition
rate appear in the numeric keypad control block display.
The transition control block display of the same bank (M/E or PGM/PST)
also shows the setting.
To enter a difference from the current value
After pressing the [+/–] button, enter the difference and press the [TRIM]
button.
To change the sign (+ or –), press the [+/–] button.
Setting the transition rate in the Multifunction Flexi Pad control
block
1
In the Multifunction Flexi Pad control block, press the [TRANS RATE]
button.
The button displays in the memory recall section change as shown in the
following illustration, and the Multifunction Flexi Pad control block
switches to the transition rate setting mode.
2
In the region selection buttons, select the switcher bank.
3
Press the [TRANS SEL] button in the memory recall section.
171
Executing a Transition