Sony DVS-9000 User Manual page 190

With ccp-8000 series center control panel

Hide thumbs Also See for DVS-9000:

Table of Contents

Setting the independent key transition rate in the numeric

keypad control block

You cannot use the numeric keypad control block to set the transition rate for

a simple transition.

To enter a difference from the current value

After pressing the [+/–] button, enter the difference and press the [TRIM]

To change the sign (+ or –), press the [+/–] button.

Setting the independent key transition rate in the Multifunction

Flexi Pad control block

For example, to set the independent key transition rate for M/E-1 key1, carry

out the following procedures.

Independent Key Transitions

In the numeric keypad control block, hold down the [TRANS RATE]

button, and in the independent key transition control block, press the

delegation button [KEY1] to [KEY4] ([DSK1] to [DSK4] in the PGM/PST

bank) for the key for which you want to set the transition rate.

The numeric keypad control block changes to the mode for inputting the

independent key transition rate, and its display now shows the

corresponding region name and the current transition rate set for the

With the numeric keypad, enter the transition rate.

• Enter a value of up to three digits.

• To clear the entry value, press the [CLR] button.

For details of frame input mode and timecode input mode, see page 168.

Press the [ENTER] button.

This confirms the entry, and the selected region name and the set transition

rate appear in the numeric keypad control block display.

In the Multifunction Flexi Pad control block, press the [TRANS RATE]

The Multifunction Flexi Pad control block switches to the transition rate

setting mode.