Sony DVS-9000 User Manual page 684

With ccp-8000 series center control panel

Hide thumbs Also See for DVS-9000:

Table of Contents

Setting the start point and stop point with the [SET XX] buttons

When you enter a timecode and make a setting with the [SET START TC],

[SET STOP TC], or [SET DUR] button in the device control block (search

dial), the timecode display changes as follows. With these buttons you can set

the start point and stop point timecodes, and the duration (the duration is not

displayed). When two of these values are set, the remaining one is

automatically determined.

Control of VTRs, Extended VTRs, and Disk Recorders

The [RCALL] button in the numeric keypad control block lights.

With the region selection buttons in the numeric keypad control block,

select the region.

You can select more than one button.

Enter the number of the register to be recalled with the numeric keypad

Press the [REWIND] button in the keyframe control block.

The VTR/Extended VTR/disk recorder automatically advances to the

timecode value set as the start point.

While the VTR/Extended VTR/disk recorder is operating, the [ALL

STOP] button in the device control block flashes amber, and when the start

point is reached lights green.

If the operating VTR/Extended VTR/disk recorder is selected as the

reference region in the device control block, the [CUE] button also flashes

and lights in the same way as the [ALL STOP] button. Also, when the start

point is reached, the [STOP] button lights amber.

Press the [RUN] button in the keyframe control block.

The VTR/Extended VTR/disk recorder is now controlled according to the

keyframe data.

Press the [SET START TC] button, and enter "00000000" from the

numeric keypad control block.

(DUR (not displayed)

Press the [SET STOP TC] button, and enter "200" from the numeric

keypad control block. This automatically sets DUR.