Snapshot Attributes - Sony DVS-9000 User Manual

With ccp-8000 series center control panel

Hide thumbs Also See for DVS-9000:

Table of Contents

To carry out DME wipe snapshots requires the BKDS-9470 DME Board Set or

the MVE-8000A/9000 DME Processor.

The rest of this section describes the snapshots that apply to a particular region

Snapshot Attributes

An individual snapshot may also have attached special conditions relating to

switcher or DME operation when the snapshot is recalled.

These conditions are called "attributes" of the snapshot, and can be added when

the snapshot is saved or recalled.

Types of attribute

There are five snapshot attributes, as follows.

Cross-point hold: When the snapshot is recalled, the cross-point button

selection remains unchanged. This can be set independently for each bus.

Key disable: When the snapshot is recalled, the key settings remain

unchanged. This can be set independently for each keyer. A Setup menu

allows you to select whether or not the key on/off state should also remain

For details of the setting operation, see "Settings Relating to Keys, Wipes,

Frame Memory and Color Correction (Key/Wipe/FM/CCR Menu)" in the

Chapter 20 (Volume 3).

Effect dissolve: The transition from the state before the snapshot recall to the

snapshot settings is carried out smoothly, by a dissolve. The dissolve

duration can be set in the Snapshot menu.

Auto transition: An auto transition starts the instant the snapshot is recalled.

The auto transition setting is valid only for M/E-1, M/E-2, M/E-3, and

If both effect dissolve and auto transition are selected as attributes, the auto

transition takes precedence.

GPI output: A GPI output is sent to the allocated GPI port the instant the

snapshot is recalled.