Sony DVS-9000 User Manual page 797

3
To apply temporary attributes, press the following buttons, turning them
on.
Control block
Cross-point control
block
Flexi Pad control
block
a) When Xpt Hold mode is selected in setup.
b) When Key Disable mode is selected in setup.
For details of the operation mode of the [XPT HOLD] button, see
"Selecting the Bank to Make the Settings" in Chapter 20 (Volume 3).
For details of temporary attributes and available attributes, see "Snapshot
Attributes" (page 785).
Notes
• The cross-point hold and key disable settings are maintained until you
next press the [XPT HOLD] button.
• Applying temporary attributes does not affect the contents of the
register.
4
Press the button in the memory recall section which shows the desired
register name.
The button you pressed lights yellow, and this recalls the snapshot.
The numeric display shows the selected register number after the bank
number.
Deleting a snapshot in the Flexi Pad control block (standard type
or simple type)
As an example, to delete a snapshot on the M/E-1 bank, use the following
procedure.
1
In the M/E-1 bank Flexi Pad control block, press the [SNAPSHOT] button.
This assigns the Flexi Pad control block to snapshot operations. The
numeric display shows the last selected bank number and the last recalled
register number on the corresponding bank.
Temporary Button
attribute to apply
A/B bus cross-point [XPT HOLD] button in the
hold background A/B bus
Key cross-point hold [XPT HOLD] button in the key bus
Key disable
[XPT HOLD] button in the key bus
Effect dissolve [EFF DISS] button
Auto transition [AUTO TRANS] button
Snapshot Operations in the Flexi Pad Control Block
a)
b)
797