System Settings For Power-Up, Reset/Part-Program End And Part-Program Start - Siemens SINUMERIK 828D Function Manual

K1: Mode group, channel, program operation, reset response

9.14 System settings for power-up, RESET/part-program end and part-program start

9.14 System settings for power-up, RESET/part-program end and part-
program start
Concept
The control-system response after:
• Power up (POWER ON)
• Reset/part program end
• Part program start
can be modified for functions, such as G codes, tool length compensation, transformation, coupled axis
groupings, tangential follow-up, programmable synchronous spindle via machine data.
The control-system
response after:
Power-up (POWER ON)
RESET/part program end
Part program start
*)
see also POWER ON [Page 795]
Example:
For certain applications (e.g. grinding) it is advisable not to apply the reset position of individual functions until the
part program start. This is possible through the appropriate setting of machine data MD20110, MD20150,
MD20152 and MD20112.
628
can be set with:
MD20110 $MC_RESET_MODE_MASK
*)
(Definition of control default settings after reset/parts program end)
MD20144 $MC_TRAFO_MODE_MASK
(Selection of the kinematic transformation function)
MD20150 $MC_GCODE_RESET_VALUES (initial setting of the G groups)
MD20110 $MC_RESET_MODE_MASK
(Definition of control default settings after reset/parts program end)
MD20150 $MC_GCODE_RESET_VALUES (initial setting of the G groups)
MD20152 $MC_GCODE_RESET_MODE
(Definition of control initial setting after reset)
MD20112 $MC_START_MODE_MASK
(definition of initial control system settings after part program start)
MD20110 $MC_RESET_MODE_MASK
(Definition of control default settings after reset/parts program end)
Function Manual, 09/2011, 6FC5397-0BP40-2BA0
Basic Functions