Siemens SINUMERIK 828D Function Manual page 844

P3: Basic PLC Program for SINUMERIK 840D sl
13.2 Key data of the PLC-CPUs for 840D sl and 840Di sl
Version screen according to the module state in STEP 7 Online
If, using STEP 7 Online, you connect to a PLC integrated in SINUMERIK, there, under the "General" tab, you can
determine the hardware version of the PLC module as well as the PLC firmware version.
The following versions are available:
Hardware
Product version
20xx
PLC 317-HW of the
840Dsl
21xx
MCI 2 Board (840Di)
23xx
PLC 319-HW of the
840Dsl
1)
Firmware release: Version of the SIMATIC CPU and specification of the SIMATIC hotfix, from which
the SINUMERIK PLC CPU is derived (e.g. V-2.1, HF10; or V-2.7, HF2).
2)
The last two positions of the software version are used within SINUMERIK to assign a PLC version
PLC basic program functions
Scope
Axes/spindles
Channels
Mode groups
Functions
Status/control signals
M decoders (M00-99)
G group decoders
Aux. function distributors
Aux. function transfer, interrupt-driven
M decoding acc. to list
Move axes/spindles from PLC
Async. subprogram interface
Error/operating messages
Transfer MCP and HHU signals
Display control handheld unit
Read/write NCK variables and GUD
844
PLC module
Firmware version
PLC 317-2DP V 2.1.10
with IBC32
PLC 317-2DP V 2.1.10
with IBC32
PLC 319-3PN/DP V 2.4.2
V 2.6.5
V 2.7.2
Designation
1) SW version operating
2)
system
20.70.41
20.72.41
24.90.13
26.90.13
27.90.06
Type of control
840Di 840D sl
See catalog 31
6 10
6 10
+ +
+ +
+ +
+ +
+ +
+ +
+ +
+ +
+ +
+ +
+ +
+ +
Function Manual, 09/2011, 6FC5397-0BP40-2BA0
Basic Functions