Siemens SINUMERIK 828D Function Manual page 955

Parameterization
Signal
PIService
Unit
WVar1
WVar2
PI service: CREACE
Function: Create tool cutting edge
Creation of the cutting edge with the next higher/next unassigned D number for the tool with the transferred T
number in TO, TS (if present). The cutting edge for the OEM cutting edge data is set up simultaneously in the
TUE block - if one is present.
Parameterization
Signal
PIService
Unit
WVar1
PI service: CREATO
Function: Create tool
Creation of a tool with specification of a T number. The tool is entered as existing in the tool directory area (TV).
The first "cutting edge" D1 (with zero contents) is created for tool offsets in the TO block. D1 (with zero contents)
is also created for the OEM "cutting edge" data in the TUE block - if one is present. If a TU block exists, it will
contain the data set for the tool.
Parameterization
Signal
PIService
Unit
WVar1
Basic Functions
Function Manual, 09/2011, 6FC5397-0BP40-2BA0
Type Value range
ANY PI.CRCEDN
INT 1 ... 10
INT
INT 1 ... 9 or
01 - 31999
Type Value range
ANY PI.CREACE
INT 1 ... 10
INT
Type Value range
ANY PI.CREATO
INT 1 ... 10
INT
P3: Basic PLC Program for SINUMERIK 840D sl
Meaning
Create new cutting edge
TOA
T number of tool for which cutting edge
must be created. A setting of 00000
states that the cutting edge should not
refer to any particular tool (absolute D
number).
Edge number of tool cutting edge
Meaning
Create tool cutting edge
TOA
T number
Meaning
Create tool
TOA
T number
13.13 Block descriptions
955