Startup Hardware Configuration Of The Plc-Cpus - Siemens SINUMERIK 828D Function Manual

13.4

Startup hardware configuration of the PLC-CPUs

General procedure
The hardware configuration for the PLC CPUs used in the NCU7x0, including other components of the NCU
(NCK, CP, HMI, drive), must be defined via STEP 7. Proceed as follows in STEP7:
1. Create a new project (File, New, Project)
2. Insert, Hardware, SIMATIC 300 station
3. Select the SIMATIC 300 station with the mouse
4. right mouse button, open object
The HW-Config is now started.
5. A suitable SINUMERIK component is selected from the hardware catalog
"SIMATIC 300 \ SINUMERIK \ 840D sl".
6. I/Os are to be extended from the hardware catalog of STEP 7
The addresses for the I/O modules can be changed, if needed.
Preconditions
In order to be able to select SINUMERIK components from the hardware catalog, you must run the Toolbox setup
program first ("Hardware expansions for STEP7" and "Starter"). The current version of hardware expansions for
STEP 7 can also be found under eSupport.
Example of current hardware allocations PLC to NCU
Table 13-1 Hardware expansions
NCU
SINUMERIK 840D
NCU 710.1
SINUMERIK 840D
NCU 720.1
SINUMERIK 840D
NCU 730.1
SINUMERIK 840D
NCU 740.1
SINUMERIK 840Di sl
with MCI2
Basic Functions
Function Manual, 09/2011, 6FC5397-0BP40-2BA0
MLFB
6FC5 371-0AA00-0AA0
6FC5 372-0AA00-0AA0
6FC5 373-0AA00-0AA0
6FC5 374-0AA01-?AA0
6FC5 222-0AA02-1AA0
P3: Basic PLC Program for SINUMERIK 840D sl
13.4 Startup hardware configuration of the PLC-CPUs
Comparable
SIMATIC CPU MLFB
included
6ES7 317-2AJ00-0AB0
6ES7 317-2AJ00-0AB0
6ES7 317-2AJ00-0AB0
6ES7 318-3EL00-0AB0
6ES7 317-2AJ00-0AB0
Selecting from STEP 7 hardware
catalog
NCU710.1
STEP 7 V5.3 SP2 and higher
and Toolbox 840D sl 01.01.00)
NCU720.1
STEP 7 V5.3 SP2 and higher
and Toolbox 840D sl 01.01.00)
NCU730.1
STEP 7 V5.3 SP2 and higher
and Toolbox 840D sl 01.01.00)
NCU740.1
STEP 7 V5.4 or later
and Toolbox 840D sl 01.04.02)
840Di with PLC 317-2 DP
STEP 7 V5.3 SP2 and higher
and Toolbox 840D sl 01.02.00)
847