Influencing The Stop Events Through Stop Delay Area - Siemens SINUMERIK 828D Function Manual

K1: Mode group, channel, program operation, reset response
9.9 Program operation mode
9.9.13

Influencing the Stop events through Stop delay area

Stop Delay Area
The reaction to a stop event can be influenced by conditioned interruptible area in the current part program. Such
a program area is called stop delay area.
Within the stop delay areas there should be no stop and the feed should not be changed. Stops do not take effect
until the program section has been completed (Example: making of a thread).
A stop delay area is defined with the part program commands:
Start a Stop Delay Area
DELAYFSTON
End a Stop Delay Area
DELAYFSTOF
References:
Programming Manual, Job Planning;
Stop events
Overview of the NCK events that cause a stop:
NCK events
Reset and mode group RESET
PROG_END
Interrupt
DELDISTOGO_SYNC
PROGRESETREPEAT
PROGCANCELSUB
SINGLEBLOCKSTOP
SINGLEBLOCK_IPO
SINGLEBLOCK_DECODIER
STOPALL
STOPPROG
OVERSTORE_BUFFER_END_REACHED
PREP_STOP
PROG_STOP
STOPPROGATBLOCKEND
STOPPROGATSUPEND
WAITM
WAITE
INIT_SYNC
MMCCMD
588
Response Stop criteria
immediate IS: DB21, ... DBX7.7 and DB11 DBX20.7
Alarm 16954 NC prog.: M30
delayed IS: "FC-9" and ASUP DB10 DBB1
immediate IS: "Delete distance-to-go" DB21, ... DBX6.2 and axial
delayed IS: "Clear number of subprogram passes" DB21, ...
DBX6.3
delayed IS: "Program level abort" DB21, ... DBX6.4
delayed In the stop delay area: NC stops at the end of the 1st
block outside the stop delay area.
Sinlge block is active before the stop delay area:
IS: "NC Stop at block limit" DB21, ... DBX7.2
delayed IS: "Activate single-block type 1" DB11 DBX21.7
delayed IS: "Activate single-block type 2" DB11 DBX21.6
immediate IS: DB21, ... DBX7.4 and DB11 DBX20.6
delayed IS: DB21, ... DBX7.3 and DB11 DBX20.5
Alarm 16954 NC prog.: Stop because of empty overstore buffer
Alarm 16954 NC prog.: STOPRE and all implicit Stopres
Alarm 16954 NC prog.: M0 and M1
delayed IS: "NC Stop at block limit" DB21, ... DBX7.2
System fault SR end should always deselect the stop delay section.
Alarm 16954 NC prog.: WAITM
Alarm 16954 NC prog.: WAITE
Alarm 16954 NC prog.: INIT with parameter "S"
Alarm 16954 NC prog.: MMC( STRING, CHAR )
Function Manual, 09/2011, 6FC5397-0BP40-2BA0
Basic Functions