Part-Program Start - Siemens SINUMERIK 828D Function Manual

K1: Mode group, channel, program operation, reset response
9.9 Program operation mode
Table 9-7 Responses to operator or program actions
Channel
Situation
status
R V A
17 x
18 x
Channel status
R --> aborted
U --> interrupted
A --> running
9.9.8

Part-Program Start

Start handling
Table 9-8 Typical program sequence
Sequence Command
1 Load program (via the operator
interface or part program)
2 Select AUTOMATIC mode
3 Program preselection
4 NC start for preselected channel
5
6
568
Program status
N V S W A
x
x
Program status
N --> aborted
U --> interrupted
S --> stopped
W --> waiting
A --> running
M02/M30/RESET
Operator or program action (Situation after the
Active mode
action)
A M J
x NC Stop (11); at JOG end (11)
x Reset (4); wait for other channel (18)
Operating modes
A --> aborted
M --> aborted
J --> aborted
Conditions
(must be satisfied before the
command)
Channel preselected
Preselected channel in
RESET state
User ID sufficient for
program preselection
NC start disable not
available
Reference point approached in
all
axes
None
Function Manual, 09/2011, 6FC5397-0BP40-2BA0
Comments
Program execution
End of program
Basic Functions