General Functions And Displays; Stop/Start/Cancel/Continue Part Program - Siemens SINUMERIK 840D Operator's Manual

4
Machine Operating Area

4.2 General functions and displays

4.2

General functions and displays

4.2.1 Stop/start/cancel/continue part program

Precondition
Cycle Start
Cycle Stop
Reset
Machine
JOG
Repos
+X X
...
4-102
Function
The following section describes how to start and stop part programs
and to resume them after they have been aborted.
Operating sequence
"AUTO" is selected in the "Machine" operating area.
No alarms are pending.
The program is selected.
Feedrate enable is active.
Spindle enable is set.
Start part program:
The part program is started and executed.
Stop/abort part program:
The program run is interrupted, but can be restarted with
"NC Start".
The current program is aborted.
Resume part program:
After interrupting the program with "NC Stop" you can retract the tool
from the contour in "Jog" mode. The control saves the coordinates of
the point of interruption. The distances traversed are displayed.
Repositioning:
Select the "Machine" operating area.
Select "Jog" mode.
Press the "Repos" key to reposition the tool on the contour.
Turning machine:
Press the "+X" or "-X" key.
SINUMERIK 840D/840Di/810D Operator's Guide HMI Advanced (BAD) – 03.04 Edition
4
03.04
Ó Siemens AG, 2004. All rights reserved