Siemens SINUMERIK 828D Function Manual page 669

Hide thumbs Also See for SINUMERIK 828D:
Table of Contents

Advertisement

System variable
$AC_ACTUAL_PARTS
$AC_SPECIAL_PARTS
Note
All workpiece counters are set to "0" when the control powers up with default values and can
be read and written independent of their activation.
Activation
The workpiece counter is activated with the machine data:
MD27880 $MC_PART_COUNTER (activation of workpiece counters)
Bit
Value
Significance
0
1
$AC_REQUIRED_PARTS is active
1
0
Alarm / signal output in case of: $AC_ACTUAL_PARTS = $AC_REQUIRED_PARTS
1
Alarm / signal output in case of: $AC_SPECIAL_PARTS = $AC_REQUIRED_PARTS
4
1
$AC_TOTAL_PARTS is active.
5
0
$AC_TOTAL_PARTS is increased by the value "1" through M02 / M30.
1
$AC_TOTAL_PARTS is incremented by the value "1" through the M command
defined with MD27882[0].
6
0
$AC_TOTAL_PARTS is also active for program test / block search.
7
1
$AC_TOTAL_PARTS is incremented by the value "1" upon a jump back with GOTOS.
8
1
$AC_ACTUAL_PARTS is active
9
0
$AC_ACTUAL_PARTS is increased by the value "1" through M02 / M30.
1
$AC_ACTUAL_PARTS is incremented by the value "1" through the M command
defined with MD27882[1].
10
0
$AC_ACTUAL_PARTS is also active for program test / block search.
11
1
$AC_ACTUAL_PARTS is incremented by the value "1" upon a jump back with GOTOS.
12
1
$AC_SPECIAL_PARTS is active.
13
0
$AC_SPECIAL_PARTS is increased by the value "1" through M02 / M30.
1
$AC_SPECIAL_PARTS is incremented by the value 1 through the M command
defined with MD27882[2].
14
0
$AC_SPECIAL_PARTS is also active for program test / block search.
15
1
$AC_SPECIAL_PARTS is incremented by the value "1" upon a jump back with
GOTOS.
Basic Functions
Function Manual, 09/2011, 6FC5397-0BP40-2BA0
K1: Mode group, channel, program operation, reset response
Description
Number of completed workpieces (actual workpiece total)
This counter registers the total number of all workpieces produced
since the start time. On condition that $AC_REQUIRED_PARTS > 0,
the counter is automatically reset to "0" when the required number of
workpieces ($AC_REQUIRED_PARTS) is reached.
Number of workpieces selected by the user
This counter supports user-specific workpiece counts. An alarm can be
defined to be output when the setpoint number of workpieces is
reached ($AC_REQUIRED_PARTS). Users must reset the counter
themselves.
9.16 Program runtime / Part counter
669

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sinumerik 840d sl

Table of Contents