Setting The Access Control Configuration - Motorola WiNG 5.5 Reference Manual

10.2 Setting the Access Control Configuration

Management Access
Refer to the Access Control
Telnet, SSH or SNMP). Access options can be either enabled or disabled as required. Motorola Solutions recommends disabling
unused interfaces to reduce security holes. The Access Control tab is not meant to function as an ACL (in routers or other
firewalls), where you can specify and customize specific IPs to access specific interfaces.
The following table demonstrates some interfaces provide better security than others and are more desirable:
Access Type
Telnet
HTTP
HTTPS
SSHv2
To set user access control configurations:
1. Select Configuration.
2. Select Management.
3. Select Access Control
screen to allow/deny management access to the network using selected protocols (HTTP, HTTPS,
Encrypted
No
No
Yes
Yes
from the list of Management Policy options in the upper, left-hand, side of the UI.
Figure 10-3 Management Policy - Access Control screen
Management Access 10 - 5
Authenticated
Yes
Yes
Yes
Yes
Default State
Disabled
Disabled
Disabled
Disabled