Motorola WiNG 5.5 Reference Manual page 508

6 - 82 WiNG 5.5 Access Point System Reference Guide
Power Hold Time
21. Set the following
NOTE: The recovery parameters within the Neighbor Recovery, Interference and
Coverage Hole Recovery tabs are only enabled when Custom is selected as the
Sensitivity setting from the Smart RF Basic Configuration screen.
5GHz Neighbor Power
Threshold
2.4 GHz Neighbor Power
Threshold
Figure 6-35 SMART RF Recovery Configuration screen - Neighbor Recovery tab
Defines the minimum time between two radio power changes during neighbor recovery.
Set the time in either Seconds (0 - 3,600), Minutes (0 - 60) or Hours (0 - 1). The default
setting is 0 seconds.
Neighbor Recovery variables for the Smart RF configuration:
Use the spinner control to set a value from -85 to -55 dBm the access point's 5.0 GHz radio
uses as a maximum power increase threshold if the radio is required to increase its output
power to compensate for a failed radio within the access point's radio coverage area. The
default value is -70 dBm.
Use the spinner control to set a value from -85 to -55 dBm the access point's 2.4 GHz radio
uses as a maximum power increase threshold if the radio is required to increase its output
power to compensate for a failed radio within the access point's radio coverage area. The
default value is -70 dBm.